View Single Post
Old 10 April 2014, 12:20   #31
Mounty
Hardware Design Engineer

Mounty's Avatar
 
Join Date: Jan 2013
Location: www.KMTech.co.uk
Posts: 372
Quote:
Originally Posted by Total Eclipse View Post
Mounty, based on the questions I was asking on the Gotek thread about having the Gotek and internal floppy both on the same internal header (as df0: and df1: respectively) on an A1200, how difficult would it be to make a PCB that has all the necessary hardware? I assume it would/could effectively be a modification of this board?
It's not possible to have the Gotek and internal floppy both on the same internal header as the internal header only has the SEL0B drive selector line and therefore can only support one drive.

The external port has the other three drive selector lines.
Mounty is offline  
 
Page generated in 0.06517 seconds with 9 queries