English Amiga Board - View Single Post - Trouble Setting up Transcend 4GB IDE Flash Disk

mfletcher · 06 January 2014, 17:08

Hi,

I recently bought one of these to replace the aging hard drive in my A4000

http://www.ebay.com/itm/Transcend-4G...item461404f31a

HDToolBox can see the drive, and I partitioned it with the following settings.

Partition name: DH0
File system: Standard File System, FFS
Mask 0x7ffffffe
Max Transfer 0x1fe0000
Block size 512
Size of partition: 1024MB

I can install WB 3.1 on the partition just fine and reboot and run it without any issues.

The problem arises after installing ASIM CDFS v3.10 which Ive used in the past with no issues. After installing it and rebooting I start getting the following errors:

DH0 has a checksum error on disk block 1056187

Ive never seen this happen before - never had this issue with other drives, both CF and 3.5" in the past. How do I go about troubleshooting this error?

Mark

06 January 2014, 17:08	#1
mfletcher Bawbag. Join Date: Mar 2008 Location: Chicago, USA Posts: 375	Trouble Setting up Transcend 4GB IDE Flash Disk Hi, I recently bought one of these to replace the aging hard drive in my A4000 http://www.ebay.com/itm/Transcend-4G...item461404f31a HDToolBox can see the drive, and I partitioned it with the following settings. Partition name: DH0 File system: Standard File System, FFS Mask 0x7ffffffe Max Transfer 0x1fe0000 Block size 512 Size of partition: 1024MB I can install WB 3.1 on the partition just fine and reboot and run it without any issues. The problem arises after installing ASIM CDFS v3.10 which Ive used in the past with no issues. After installing it and rebooting I start getting the following errors: DH0 has a checksum error on disk block 1056187 Ive never seen this happen before - never had this issue with other drives, both CF and 3.5" in the past. How do I go about troubleshooting this error? Mark