Thread: ACA500 tested
View Single Post
Old 02 January 2014, 16:53   #265
Zone Friend
Join Date: Jul 2005
Location: Toronto, Canada
Posts: 672
I formed the base for the case. Drilled the holes at the back to secure the cover in place, then I used a heat gun to warm up the plastic then bent it screwed it down the heated it again to get a good form to the base. The case is 6 inches wide. I could have gotten away with 5 inches, but I have the room on the desk and I wanted to make sure I had room for all 4 USB ports from the Subway. As well if there are other expansions to be added, I wanted to make sure that there would be room in the case for later.

Here is a picture of the A500 that will have the ACA 500. These are mods that I did a couple years ago when I had the VXL 030 and scan doubler. I had to make the extension because the VXL covered Denise. I added the fans to help improve circulation due to all the extra cables and hardware inside the case.

Last edited by source; 02 January 2014 at 20:20.
source is offline  
Page generated in 0.03925 seconds with 10 queries