View Single Post
Old 12 August 2013, 21:16   #54
Schoenfeld
electricky.
 
Join Date: Jun 2010
Location: out in the wild
Posts: 1,243
New x-surf-100.device driver V1.8 uploaded to http://wiki.icomp.de/wiki/X-Surf-100

Device now checks if Z3 autoconfig worked, and if board is at an address where it can actually work (MSB of base address must be 0). If Mediator logic board is found to be the cause, a requester should open that tells the user to close the "swap config" jumper.

The 2MBytes/s barrier has been broken today:

http://www.a1k.org/forum/showpost.ph...&postcount=451

Jens
Schoenfeld is offline  
 
Page generated in 0.04859 seconds with 9 queries