View Single Post
Old 29 December 2012, 19:24   #1809
Registered User

Join Date: May 2006
Location: Kilmacolm
Age: 40
Posts: 619
Originally Posted by roy bates View Post
no it wouldent work if the chip was faulty its an upscaler so it would need the signals that are generated from that to work.
I'm not sure about that, I think it might work. I think the indis work using FPGA recreations of Lisa/Denise and snoop on the inputs to these chips to recreate the display rather than capturing the outputs and SD/FFing them. Otherwise the special modes would not be possible because the original display generators do not support them. What do you get on the RGB port when using a HiGFX screen mode? Black screen I think?

Has anyone tried eg, an A500 with indi ECS and no denise. You will get no RGB output but does the indi still produce a complete display with proper mouse movement? Assuming indiAGA is the same idea then maybe this would work. ie. original built in display outputs are faulty but indi output is good.
jimbob is offline  
Page generated in 0.04033 seconds with 10 queries