View Single Post
Old 29 October 2012, 17:27   #6
Our prices are Insane!
Join Date: Jun 2012
Location: Edmonton
Posts: 465
Originally Posted by dJOS View Post
I got one recently but the problem I found is the pins come out very easily if you arent very quick soldering them in - I'f I buy any in future I'll be using my hot glue gun to lock the pins in-place before I attempt to install them.
there are 2 very simple ways to avoid the glue.
One the legs are longer the the motherboard, so once inserted, Just bent the legs a bit outward on the bottom to avoid it sliding
or if the legs are not long enough to bend, just use electrical tape temporarily to hold it it in place.
On my facebook page, I have a photo album where on Saturday, I replaced the battery in a Blizzard PPC card and the legs of the holder where just barely longer than the with of the board. You can see I used electrical tape and just removed it after solder.
quarkx is offline  
Page generated in 0.03902 seconds with 10 queries