View Single Post
Old 21 September 2012, 13:57   #16
Bishmanrock
Registered User

Bishmanrock's Avatar
 
Join Date: Oct 2010
Location: UK, North East
Age: 29
Posts: 24
Quote:
Originally Posted by fgh View Post
Try configuring WinUAE again from scratch (from a QuickStart), and add the card again?
Some progress! The CF is now recognised in WINUAE, although when I boot it with a Workbench disk in the old partition shows up with :NDOS on the end, but is inacessible.

If I go into HDToolbox now, when I go into Change Drive Type I get two (KINGSTON and UAE-IDE), whichever one I go on if I do Read Configuration and then try to save it just gives me a "Volume Install3.1 is full", I'm not quite sure why it's referencing that.

I think my own inexperience probably lead me to this point, I probably broke it without realising.

Quote:
Originally Posted by daxb View Post
If you change WHDLoad.prefs (NoWriteCache) then write access to HD will take place immediately but you might dislike that.
Didn't know about this, thanks for mentioning it, I can't imagine why I'd dislike it though.
Bishmanrock is offline  
 
Page generated in 0.08440 seconds with 9 queries