View Single Post
Old 25 June 2012, 16:56   #2529
Registered User
Join Date: Dec 2009
Location: Madrid / Spain
Posts: 27
Originally Posted by Schoenfeld View Post
Correct. 68EC020@16.6MHz with all the 0-waitstate fastmem the thing can address, plus Maprom - that is the plan. However, that's just a theoretical thing in my CAD system.

I use NedoPC's A608 and it can be configured to use 5.5MB of fastmem without blocking PCMCIA port. 68EC020 means it won't be able to use more than 5.5MB of fastmem without blocking PCMCIA port, right?

Perhaps another 0.5MB could be added for the MAPROM if the same addresses are used and still keep the 5.5MB.

Would a full 020 make the design much more expensive?
Crumb is offline  
Page generated in 0.03924 seconds with 10 queries