View Single Post
Old 28 May 2012, 01:20   #1237
Registered User
Join Date: Sep 2011
Location: MIAMI/USA
Posts: 72
Originally Posted by golem View Post
I booted my mig out the case on a towel and bridged E127R with a screwdriver. It did take away the artifacts I was seeing initially after boot. So sorry bbond007 I think you were right. My board is Escom 1D4. However, I got a bit too confident and tried to solder over the resistor. I crashed and burned and the resistor came off the board and I can't get solder to bridge the gap. either I am inept or my soldering iron is too hot. I am no good at this stuff! I am hoping Amigakit can come to the rescue I have sent them an email
Just take your time and try what diablothe2nd said with the wire or i think i used the leg of a resistor you'll get it...
bbond007 is offline  
Page generated in 0.03995 seconds with 10 queries