View Single Post
Old 27 May 2012, 23:29   #1230
golem
Registered User
 
Join Date: Apr 2012
Location: Nottingham, UK
Posts: 31
I booted my mig out the case on a towel and bridged E127R with a screwdriver. It did take away the artifacts I was seeing initially after boot. So sorry bbond007 I think you were right. My board is Escom 1D4. However, I got a bit too confident and tried to solder over the resistor. I crashed and burned and the resistor came off the board and I can't get solder to bridge the gap. either I am inept or my soldering iron is too hot. I am no good at this stuff! I am hoping Amigakit can come to the rescue I have sent them an email
golem is offline  
 
Page generated in 0.04877 seconds with 9 queries