View Single Post
Old 26 May 2012, 17:51   #1217
ajk
Registered User
ajk's Avatar
 
Join Date: May 2010
Location: Helsinki, Finland
Posts: 939
0805 would be a surface mount resistor, ie. a little ~2 mm long rectangle without any wires. Maplins must not be a very electronics oriented store But you can bend the wires on that to suit the pad arrangement and solder it in, if you need the fix done sooner rather than later. It's not going to be flush with the PCB though so make sure nothing can snag on it and destructively pull it off the board.
ajk is offline  
 
Page generated in 0.05696 seconds with 9 queries