View Single Post
Old 21 May 2012, 09:43   #10
roy bates
Registered User
 
Join Date: Apr 2011
Location: birmingham
Age: 48
Posts: 2,819
are you using drap with remapollo?

are you using remapollo in your startup sequence as it loads hold control and c to disable it,i think so it dont take the 512k from fastram,and....if in the startup drawer just remove it temporary for the demos.

im sure the nofastram command turns all the fastram off and on completly,so not sure if that will help you run these.yes its in 3.9 as well

also,if your running 3.9 with a backdrop.try to turn it off and/or make sure its set to use fastram in prefs/workbench to other mem and the quality to good and starting workbench in a low/mid screenmode to save memory no interlace.

hope this helps.......a bit.

Last edited by roy bates; 21 May 2012 at 09:56.
roy bates is offline  
 
Page generated in 0.04813 seconds with 9 queries