View Single Post
Old 04 May 2012, 10:55   #790
Registered User

diablothe2nd's Avatar
Join Date: Dec 2011
Location: Northampton, UK
Age: 36
Posts: 1,232
Ok here comes a bunch of photos for kipper

ignore the timestamp, i haven't had my cell phone switched on since that date since i never use it

I've included my scale ruler to hopefully make dimensions easier for you

all these photos were taken with two risers installed.

the line i've drawn on the next image is where the connector clashes up to. i'll need to flatten these pins too:

this shows the modification to the clamp on the cable connector, i took the clamp off and shaved a little off it so the cable comes straight out rather than up

this just shows the modification working as intended

this shows where the connector is fouling on the remaining unflattened pins of the fastata even with two risers

these are with the connector pulled clear of the remaining pins. the ata sits properly without warping now:

second post with more coming (15 image cap, sadly)

Last edited by diablothe2nd; 04 May 2012 at 11:17.
diablothe2nd is offline  
Page generated in 0.04025 seconds with 10 queries