View Single Post
Old 06 August 2011, 19:27   #1
alkis21
Zone Friend
alkis21's Avatar
 
Join Date: Jul 2002
Location: Athens, Greece
Age: 42
Posts: 1,276
Send a message via MSN to alkis21
DiskImage: How does it work?

There must be an easy and embarrassing answer to this, but I can't figure it out so I'd appreciate it some help.

I installed DiskImage on my A1200 but I can't get it to work. What I do is this (in shell, but using the GUI gets me the same result):

-I mount the drive DI0: by double clicking it in Storage/DOSDrivers
-I type DiskImageCtrl unit 0 insert test.adf (a DOS disk I'm using to test it)
-I then type DiskImageCtrl to confirm that I did it correctly, and sure enough, the following line is on top of the list:
unit 0: DI0: "HD:A/4/TEST.ADF" (read/write)

The question is, what then? I thought I'd only need to type DI0: in Shell to access the contents of the disk, but when I do I get an Unknown command error.

What am I doing wrong?

Last edited by alkis21; 06 August 2011 at 19:54.
alkis21 is offline  
AdSense AdSense  
 
Page generated in 0.04800 seconds with 9 queries