Quote:
Originally Posted by fitzsteve
Its very strange indeed as I used to have the very same card and ran Classic Workbench without issues.
As you're using >4gb did you patch the SCSI.Device? I wonder if this causes some issue with the M-Tec, do you have a CF-IDE or smaller HDD you can try?
All the best,
Steve.
|
didnt patch the scsi.device. i have other drives knocking about and also a cf card . I think i will go back too square one using a new drive/cf card and see how things go. cyberdruid has translated the manual back into english (it was in german) so i can check the jumper settings and suchlike.
Fitzsteve can you remember what settings you were using on card ie: the card at the moment is set to use async instead of 28/14mhz is this correct ?
Anyways thanks for the help so far both of you much appreciated
i will keep you updated on any progress, if not keep an eye on the marketplace
