View Single Post
Old 18 April 2011, 13:30   #4
fitzsteve
Professional slacker!
fitzsteve's Avatar
 
Join Date: Jul 2009
Location: Kent, UK
Age: 37
Posts: 6,340
Send a message via MSN to fitzsteve
@manicx

You don't need to change the drive type, Amigakit would have already set this up for you. As long as you clear the startup fault (I think Thomas has already given you the solution) then you should be all set.

The information you have when you go to HDToolBox is from when you setup your old drive, this information is saved and was rememberd when you copied workbench to your new CF, it does not mean your system thinks you have a WD HDD.

If you create a new definition for the CF card then you would see that also in the list however if you do that all the data would be lost so I suggest you don't do that unless you decide at some point you want to re-partition your CF.

All the best.

Steve.
fitzsteve is offline  
 
Page generated in 0.04939 seconds with 9 queries