Thread: .DMS Access?
View Single Post
Old 04 August 2001, 01:13   #14
Dengle
 
Posts: n/a
Roll eyes (sarcastic) My results:

Here's what I did using Winfellow:

Got into workbench, copied the following into Ram:
Xdms.exe
Crc.exe
Disk.dms

Set off Xdms on its little mission to crack the file with:
Xdms c Disk.dms

About 20 minutes later it stopped and gave me a hex reading #---- (obviously the #---- was a series of hex digits but I forget now). Then after reading the supplied .readme file I type up:
XDms -p #---- x Disk.dms

Then it comes up with 'probably the wrong password' - well why did the Crc program stop searching then? Maybe the experts here could take a closer look at the Crc.exe file as it initiates plenty of options when run through workbench which I don't understand. Or have you all gone to bed?
 
 
Page generated in 0.04737 seconds with 9 queries