View Single Post
Old 19 February 2011, 05:48   #1843
Precious & fragile things

Join Date: Feb 2009
Location: Victoria, Australia
Posts: 1,945
Originally Posted by Cammy View Post
My ACA1230 doesn't fit inside the A1200's case. I'm not sure if it would even work, because the connector hasn't been fully pushed through onto the board. I guess I'll have to send it back to Germany for repairs, and postage from Australia is killer.

It's just my luck that I get the faulty one.

The second picture shows that the edge connector hasn't been soldered flat to the PCB and this will cause two issues.

1. It will place stress on the connector and edge connector when it's plugged in.

2. It will adjust the angle that the card sits at and from what I hear there's not much clearance in the first place.
Loedown is offline  
Page generated in 0.03896 seconds with 10 queries