View Single Post
Old 18 February 2011, 14:47   #1819
Schoenfeld
electricky.
 
Join Date: Jun 2010
Location: out in the wild
Posts: 1,243
Quote:
Originally Posted by Cammy View Post
It's just my luck that I get the faulty one.
It's surely not faulty. True, there are variations in the height of the connector, but every single card is tested before it leaves. Only if it works properly, the golden sticker is applied.

Please try exactly the way as described in the manual: Lift the back of the card to align the connector with the board edge of the A1200, then push it in. It's a tight fit, maybe takes a little getting used to if you come from the old black connectors that have no defined push force on each of the 150 contacts.

Jens
Schoenfeld is offline  
 
Page generated in 0.05472 seconds with 9 queries