The saga continues... :-)
"I installed the revised AmigaOS Update [that was in the Zone] and it still fails unless I use "SKIPROMUPDATES exec.library". However, it
fails differently than the other version. Instead of the infinite reboot
error loop it will give a software error or recoverable error and sometimes
boot successfully and then crash when I load an application. Since, I could
at least get bootmenu to boot with no startup-sequence I decided to run
Setpatch from the shell and redirect the output to a text file which is
included below.
My accelerator card is a C= A3640.
Checksum failure! exec.library, exec 45.22 (24.07.2010) by Cosmos
AMIGA ROM Operating System and Libraries
Copyright © 1985-2002 Amiga, Inc.
All Rights Reserved.
SetPatch (V44.38) has already been installed. Patch list:
68040 Support Code Loaded
Enabled Advanced Graphics Modes
ramlib signal usage
stack size check for CON:, RAW:, RAM:, PAR:, PRT:, SER:
graphics/WritePixelLine8()
graphics/WriteChunkyPixel()
Enabled data cache
Checksum failure! exec.library, exec 45.22 (24.07.2010) by Cosmos"
|