View Single Post
Old 11 October 2010, 21:39   #2
th4t1guy
Registered User
th4t1guy's Avatar
 
Join Date: Mar 2002
Location: Kansas City, MO, USA
Posts: 570
AFAIK, there is no way to do this that would be the same as switching to PAL from the boot menu.

However, there are some tricks you can do such as running a program to switch to PAL when booting workbench. If you dig around old threads here, there's a few cases where some people have soldered some bit on the cd32 motherboard and got it to boot up as PAL, although I believe there were a few problems and it was not necessarily truly in PAL mode.

However, if you are running WHDLoad games in workbench, you can set it to run in PAL, and that should be good enough.
th4t1guy is offline  
 
Page generated in 0.03870 seconds with 10 queries