View Single Post
Old 27 December 2009, 20:14   #28
misjah
Registered User
 
Join Date: Aug 2009
Location: Zanzibar
Posts: 59
I wanted to remove floppy completely before all this (and use external if needed). The only problem is that when there is no floppy attached WB stops responding after finishing boot process. The cursor is in ''clock/loading'' mode all the time and nothing happens. This is probably because I copied MS0 and MS1 for automount. Will try again when remove them.
There was also problem when both external and internal floppy drives are attached, RAM is back to 1MB!?
Is there any way to ''trick'' external floppy to work like DF0 since It`s not possible to boot from it directly. (even when there is no HDD and DF0 attached to the board)

I used EDO Ram chips (512KB) from some S3 trio PCI graphic card. OKI Japan is manufacturer.
misjah is offline  
 
Page generated in 0.04622 seconds with 9 queries