View Single Post
Old 27 December 2009, 20:04   #27
Allen1
Registered User
 
Join Date: Nov 2009
Location: Blyth England
Age: 61
Posts: 725
It is good to see that you managed it, what chips did you use, the ones I have seen in a couple of posts look like 256K instead of 512k that I would have expected. On the other posts, the unused legs were bent under the dip as were the legs with the soldered on wires, it was also mentioned that the floppy drive screw can cause a short as it may come into contact with the nearest dip and either the removal of the screw or some hefty insulation tape were required to stop the risk of a connection/short.

Good on you M8
Allen1 is offline  
 
Page generated in 0.05966 seconds with 9 queries