View Single Post
Old 26 October 2009, 00:35   #7
PowerPie5000
Miggy Ate My Hamster!
PowerPie5000's Avatar
 
Join Date: Nov 2008
Location: Blackpool, UK
Posts: 1,561
I'm having trouble with IDEfix loading my 4th partition (HD3. My hard drive is 4.3gb and the last partition goes over the 4gb limit! I cannot see it in WB 3.1 or Amiagasys 4 even after i install IDEfix!

My startup-sequence displays the following lines at the beginning:

;BEGIN IDEfix
If Exists C:IDEfix
; you may want to exchange the following line with loadIDE reset quiet
; to make IDEfix reset resident, or loadIDE start quiet
; to start IDEfix immediately and have it reset resident
; from the next reboot. Make sure to put loadIDE behind any Kickstart mappers
C:IDEfix
Endif
; END IDEfix

I'm new when it comes to IDEfix as i've never needed to use it... but i now have a drive with lots of cool stuff on the 4th partiton that i cannot access

Last edited by PowerPie5000; 26 October 2009 at 00:52.
PowerPie5000 is offline  
 
Page generated in 0.07269 seconds with 9 queries