English Amiga Board - View Single Post

ceaser · 02 October 2009, 13:38

I e-mailed the guy. I'll have him do any soldering that needs doing. Not going to mess up my nice board. But too bad about the problems with it. I did fresh WB install then put only the disk labelled Merlin-144 install and ran the script. It works pretty good now but the problems listed on the FAQ with especially the memory exist. I guess it's above 8 bit it won't use the full 4 MB of graphics RAM on the board. It's there in showconfig so too bad. But I guess ProBench just screws it up for me unless I had these fixes done by the creator. Got it working decent again now though, just not so hot on all resolutions. It looks pretty funny right now at a VGA 31 kHz 680x510. The actual usable screen is in the upper right even though the display fills the monitor. But the mouse will move anywhere on the screen. So yes some problems with certain resolutions look.

02 October 2009, 13:38	#3
ceaser Registered User Join Date: Jun 2009 Location: Robbinsdale / Minnesota Posts: 54	thanks for the link! I e-mailed the guy. I'll have him do any soldering that needs doing. Not going to mess up my nice board. But too bad about the problems with it. I did fresh WB install then put only the disk labelled Merlin-144 install and ran the script. It works pretty good now but the problems listed on the FAQ with especially the memory exist. I guess it's above 8 bit it won't use the full 4 MB of graphics RAM on the board. It's there in showconfig so too bad. But I guess ProBench just screws it up for me unless I had these fixes done by the creator. Got it working decent again now though, just not so hot on all resolutions. It looks pretty funny right now at a VGA 31 kHz 680x510. The actual usable screen is in the upper right even though the display fills the monitor. But the mouse will move anywhere on the screen. So yes some problems with certain resolutions look.