View Single Post
Old 08 January 2009, 07:19   #619
Posts: n/a
I am finally starting to get a bit tired of this bloody indivision, i have been sanding down the plastic day after day trying to make it stay and it is just getting loser and less stable. a bit of a waste of of my 140 quid now

Right now I found out why it was not working when I was sanding it down, I was sanding in the wrong place ... the inside of the socket now one of the pins has broken off after I figured out I needed to sand down the top part. A major bugger up, so now the board is tight but a shite picture lol, hopefully I can figure out how to replace the socket maybe.

Last edited by ami_junkie; 08 January 2009 at 08:44.
Page generated in 0.03857 seconds with 10 queries