View Single Post
Old 23 October 2008, 00:17   #516
Registered User
NovaCoder's Avatar
Join Date: Sep 2007
Location: Melbourne/Australia
Posts: 3,349
Originally Posted by frost242 View Post
I would like to know if there is any solution for the issue with some HP branded Lisa chips ?
I can't use my Indy AGA properly because of the bad fitting of the device on the Lisa chip
There already is a solution, it's on this thread somewhere (basically it involves sanding down the plastic so it can sit flush with the MB).

Make 100% sure that you need to do it first as it might just need to be pushed down properly.
NovaCoder is offline  
Page generated in 0.04518 seconds with 9 queries