View Single Post
Old 03 October 2008, 18:59   #462
illy5603
Registered User

illy5603's Avatar
 
Join Date: Jul 2008
Location: SPaT CiTY
Posts: 546
Send a message via MSN to illy5603
Quote:
Originally Posted by Oliver_A View Post
Scanlines only work in PAL/NTSC noninterlaced modes. The change of display settings will not be visible unless you set "Use Display Timing" to "from User Settings" and choose your screen mode in the User Display Properties using "Next Mode".
Thanks for this. How about the other settings like scan frequency etc? if they are also ignored in highgfx modes that would explain everything. I actually have the card working fine except for problems with it not displaying after some reboots as others have reported but I can live with that too.

Also, thanks for all the work you are doing. I don't want to just it here and complain.
illy5603 is offline  
 
Page generated in 0.04677 seconds with 9 queries