View Single Post
Old 28 April 2002, 22:22   #14
oldpx
 
Posts: n/a
I removed Bvision from the PPC board and noticed that the board is slightly bent because of the tight screws. I loosened them a bit. Actually it took around half an hour this morning to boot properly but after that, it didn't fail at all. I didn't install anything that forces the hardware though. Anyway I'll try to install a serious system with CybergraphX 4 tomottow. Let's hope it will be stable. I hope I'm not boring you with these problems.
 
 
Page generated in 0.07548 seconds with 9 queries