English Amiga Board - View Single Post

30 April 2008, 23:44

i got this cf to ide card too from same seller, but when hdinstall was run it read the configuration showing corrupted characters, and when trying to save it gave Error 4 in device description. Did any of you have this issue. I tried 2 different CF cards, a 256mb SIMPLETECH (which shows as a hitachi), and a 512mb Hagiwara (which shows up as a toshiba).

Lastly i then took closer look at the card and it appeared to have blobs of solder bridging where there should be any (in between some of the back of 2 cf pins and also on a little chip there was 3 pins soldered together to the right top of the board when you hold it so you can read the "2.0mm ADAPTER V.B1").

Did any of you have issues with this board and how did you solve them.

Thanks

30 April 2008, 23:44	#9
martingclark Posts: n/a	i got this cf to ide card too from same seller, but when hdinstall was run it read the configuration showing corrupted characters, and when trying to save it gave Error 4 in device description. Did any of you have this issue. I tried 2 different CF cards, a 256mb SIMPLETECH (which shows as a hitachi), and a 512mb Hagiwara (which shows up as a toshiba). Lastly i then took closer look at the card and it appeared to have blobs of solder bridging where there should be any (in between some of the back of 2 cf pins and also on a little chip there was 3 pins soldered together to the right top of the board when you hold it so you can read the "2.0mm ADAPTER V.B1"). Did any of you have issues with this board and how did you solve them. Thanks