View Single Post
Old 04 April 2008, 13:36   #1
blade002
Zone Friend
blade002's Avatar
 
Join Date: Dec 2005
Location: Australia
Age: 43
Posts: 2,442
Startup-Sequence

I will get straight to the point. I just installed Allegro CDFS after installing my EIDE Buffered Interface and now when my system boots i just get a blank screen.

Now i have tried to access the Startup-Sequence via boot with no-startup with JanoEditor ( included in ClassicWB ) but when it tries to load it asks for ENV, so i cancel and then go into file selection to access the Startup-Sequence, i click on it and nothing comes up.

So then i assign ENV only to find that although it no longer asks for ENV but when i choose Startup-Sequence again it just hangs and reboots.

I used to have CED here on disk, but i can't seem to find it Is there another way around this problem?
blade002 is offline  
AdSense AdSense  
 
Page generated in 0.07463 seconds with 9 queries