View Single Post
Old 24 February 2007, 19:32   #1
AMIGrAve
Registered User
AMIGrAve's Avatar
 
Join Date: Feb 2007
Location: Brussels / Belgium
Posts: 24
Executing command contained in .info files

Hi all,

Is there a command or something which allows to execute the command specified in an .info file from CLI as if I had clicked on it from workbench ?

In fact I never use workbench, I'm always in a shell. Usually I use a hex viewer on the .info file and have a look at the bottom of the file so I can see the command. But when the command is complex and uses parameters, it's quite hard to tell in a hex editor.

I guess I'm doing all wrong and that there's an easy way to do this. Maybe a command I'm not aware of.

Someone can help ?

PS: don't know if this is the good forum for this.
AMIGrAve is offline  
AdSense AdSense  
 
Page generated in 0.04871 seconds with 9 queries