English Amiga Board - View Single Post

03 February 2007, 12:32

I was salvaging some floppies and found two basic programs from the Abacus book "Amiga 3D graphic programming in Basic", a 'tracer' and a 'tracer editor'.

There was also an assembly 'set point' routine required by the 'tracer' program.

I was not able to salvage this routine.

Does anyone have a copy of the book?

Could someone reply with this short routine.

Thanks...

03 February 2007, 12:32	#1
MidJasper Posts: n/a	SetPoint routine I was salvaging some floppies and found two basic programs from the Abacus book "Amiga 3D graphic programming in Basic", a 'tracer' and a 'tracer editor'. There was also an assembly 'set point' routine required by the 'tracer' program. I was not able to salvage this routine. Does anyone have a copy of the book? Could someone reply with this short routine. Thanks...