View Single Post
Old 04 May 2006, 22:39   #1
spirited
 
Posts: n/a
Floppy disk Can't get RAD: working??

Hi there

I have a problem with RAD:

I boot my Amiga 1200 to Workbench with the Workbench 3.1 disk, go to shell and then I mount RAD:. It is mounted without any error messages, but when I try to access RAD:, the Amiga does not recognize it. Also when I type the "info" command RAD: does not show on the list. If I then load a software called "FixDisk"(it's a program that can recover and fix data), RAD: however shows in "FixDisks" drive list. If I reset the Amiga RAD: does not show up in the early startup menu as it normally should.

My Workbench 3.1 disk is unaltered.. I've made no changes to it, so the RAD: mountfile is the original file that comes with Workbench 3.1. I tried WinUAE on my PC with Workbench 3.1 and mounted RAD: there and it worked perfectly. I then copied the RAD: mountfile from my WinUAE Workbench 3.1 to the one I have in the Amiga 1200, but the result was the same as earlier.

Any ideas what I am doing wrong here? I can't really find any errors in the RAD: mountfile.

I'm using a Amiga 1200 with 8 MB extra memory (2 MB CHIP and 8 MB FAST). The Amiga has no harddrive, extra disk drive or anything else extra, just the memory expansion.
 
AdSense AdSense  
 
Page generated in 0.08025 seconds with 9 queries