View Single Post
Old 05 December 2005, 10:28   #1
keropi
.
 
Join Date: Oct 2004
Location: Ioannina/Greece
Posts: 5,038
How can I make the volume settings of the soundcard to apply on boot?

OK, I discovered that the volume settings of the Terratec 128i which is plugged on my g-rex are not effective immediately after the os loads, I noticed this because I have connected the paula output to the line in of the terratec, and when I run some whdload games I had no sound... if I just open the volume control prog, the settings get applied and there is sound from the line in... is there a way perhaps to put the volume control in startup-sequence?
keropi is offline  
AdSense AdSense  
 
Page generated in 0.05047 seconds with 9 queries