View Single Post
Old 01 December 2005, 21:27   #5
Registered User
Join Date: Nov 2005
Location: Netherlands
Age: 38
Posts: 16
Send a message via ICQ to Monolith Send a message via MSN to Monolith
Originally Posted by Bamiga2002
After you're prompted to boot, boot with no startup-sequence and write INFO. If your drives show up there, format them with FORMAT smthng like:

Format DRIVE dh0: name Workbench

Or whatever your drive is and do that to other new partitions aswell. Now do they show up in WB?

Btw. don't LOW-LEVEL format your drives, it destroys the drives info!!!! (this is in IDE)
It isn't necessary anyway.
Great! I'll try that. I've tried to format them from the CLI, but that didn't work, though. Booting without a startup-sequence is done in the pre-boot screen and then disabling the startup-sequence?

BTW, could I have ruined the drive by low-level formatting it??
Monolith is offline  
Page generated in 0.06738 seconds with 10 queries