View Single Post
Old 01 December 2005, 16:51   #1
Monolith
Registered User
 
Join Date: Nov 2005
Location: Netherlands
Age: 37
Posts: 16
Send a message via ICQ to Monolith Send a message via MSN to Monolith
Installation woes

Well, after finding my A600 a new HD, I was happily off to install WB2.1. However, both HDToolbox and HDsetup happily low-level format and partition my 540Mb HD as FFS, but after rebooting, neither of the partitions show up on the workbench screen.

So:

-HD spins up -check
-HDToolbox recognizes HD -check
-HDToolbox low-level formats and verifies HD as SDH0: and SDH1: -check
-HDToolbox partitions HD -check
-HDToolbox saves changes to HD -check
-HDToolbox prompts me to reboot and format the partitions -check

I reboot, and nothing shows up. What's going on?
-

Last edited by Monolith; 01 December 2005 at 17:39.
Monolith is offline  
AdSense AdSense  
 
Page generated in 0.04867 seconds with 9 queries