View Single Post
Old 15 November 2005, 19:15   #8
stainy
Zone Friend
stainy's Avatar
 
Join Date: Mar 2001
Location: Concord, NC, USA
Age: 46
Posts: 1,386
Send a message via ICQ to stainy Send a message via MSN to stainy
You can`t make it appear in WinUAE as DF0: because they are emaulated.. you can make it appear as Cat: by introducing multidisk.device to DEVS and CAT to dosdrivers. Also remember to check the catweasel box under `misc` in Winuae to use the joyports
Sids and reading disks are fine here.. it`s the writing to which has the problem..
Apparently the imagetool starts writing to the floppy before it`s ready... so I was told to press write, wait until the progress bar moves.. then hit cancel.. then hit write again.. but I`ve only got this to work once!!!!
stainy is offline  
 
Page generated in 0.05111 seconds with 9 queries