View Single Post
Old 14 August 2005, 15:32   #26
Halvare
 
Posts: n/a
Quote:
Originally Posted by thomas
I don't see why you find it so difficult to configure your network.

Here are step-by-step instructions for MiamiDeluxe.

The values are taken from my config, so you should adjust them.

You need the following data:

- The name of your ethernet driver (e.g. DEVS:Networks/via_rhinepci.device)
- The IP address of your router (e.g. 192.168.1.254)
- The IP address you want to dedicate to your Amiga (e.g. 192.168.1.6)
- The IP address of your ISP's DNS server (e.g. 194.25.2.129)

Then start MiamiDx without a config and follow these steps:

Hardware
New
Ethernet
Name = MyNetworkCard
Type = SANA-II
Driver = DEVS:Networks/via_rhinepci.device
Unit = 0
SANA-II parameters
Query device
Ok
Ok
Interfaces
New
Ethernet
LAN
Ok
MyNetworkCard
Ok
IP address = 192.168.1.6
Netmask = 255.255.255.0
Gateway Pri = 1
Gateway = 192.168.1.254
GUI default = Yes
Ok
Database
DNS servers
Add
IP address = 194.25.2.129
Online
Save Settings

I hope this helps.
HI THERE,
Was looking at this guide and mine willn't work :/
I grabbed a 10Mbps pc card off ebay which had a cur down version of amitcp/ip and a ftp client to pc server. It uses the 3c589.device for a 3com 3CCE5589EC PC card.

The problem I get is when I query the card in the hardware section I get a error ( Miami Deluxe is unable to open SANA-II device "DEVS:Networks/3c589.device' Unit 0"

Anyone have any ideas, as all my amiga know how run out over 10 years ago :/

Thanks...
 
 
Page generated in 0.05389 seconds with 9 queries