English Amiga Board - View Single Post - 5.2 crash when switching screens with RTG and 386 bridgeboard.

Toni Wilen · 20 April 2024, 08:55

Config looks fine but there is no need for cycle-exact settings unless you run programs that fail if CPU is too fast. Much quicker boot too when testing different settings. (cycle exact off, fastest possible on). JIT can cause side-effects when combined with accelerator board emulation, better keep it off until everything else works.

Also set ROM panel UAE boot ROM to 128k direct (F0 would conflict with A26x0 boot ROM). Not related to graphics problems but this config probably causes UAE ROM to "shadow" A26x0 ROM.

Does graphics work without glitches if you set RTG panel SVGA board to use monitor 2 (SVGA opens in separate window, no need for END+F9 switch).

I suspect screen size limits are not checked correctly in some situations when "switching" monitors in same window.

20 April 2024, 08:55	#2
Toni Wilen WinUAE developer Join Date: Aug 2001 Location: Hämeenlinna/Finland Age: 49 Posts: 26,536	Config looks fine but there is no need for cycle-exact settings unless you run programs that fail if CPU is too fast. Much quicker boot too when testing different settings. (cycle exact off, fastest possible on). JIT can cause side-effects when combined with accelerator board emulation, better keep it off until everything else works. Also set ROM panel UAE boot ROM to 128k direct (F0 would conflict with A26x0 boot ROM). Not related to graphics problems but this config probably causes UAE ROM to "shadow" A26x0 ROM. Does graphics work without glitches if you set RTG panel SVGA board to use monitor 2 (SVGA opens in separate window, no need for END+F9 switch). I suspect screen size limits are not checked correctly in some situations when "switching" monitors in same window.