View Single Post
Old 15 October 2004, 05:58   #10
HCF
Zone Friend
 
Join Date: Oct 2004
Location: here
Age: 47
Posts: 97
How do you install the program ? Do you boot from disk or Workbench ?? If you are using a Workbench disk, you should check out the startup-sequence on the first disk, most likely it is an assigned device...If neccessary just try to use Assign in the CLI to assign it to ram:envarc or something like that...

And if you want to toy around, maybe try Seka Assembler !
HCF is offline  
 
Page generated in 0.04452 seconds with 9 queries