Quote:
Originally Posted by Jope
The seconds are frozen if you are in set mode, but they should be running when you are not.
|
Exactly.
Quote:
Originally Posted by Jope
Sounds like you need to do some rework near the RTC chip, in case there are bad solder joints.
|
Oh god, i'm hoping not. I was so careful with that board, and put a lot of attention and time into it, testing it fully with my meter and high intensity magnifying headset and then caked a load of solder mask all over the exposed areas. I'd probably have to remove the solder mask now if i wanted to do anything else with it. I'll go over it again with my meter while it's cold, and see what that brings up.