English Amiga Board - View Single Post

dalek · 23 May 2019, 01:28

Nice guide - great writeup.

I did the same but stupidly didn't take any pictures. What I did was put the adaptor inside the PSU case - drilled holes in the left hand side - if you look at your second to last picture it went flat against the left panel on the inside. That way the wires running out look original.

Only issue with that is to try and keep the bolts flush on the outside, as on the A2000 a card in the CPU slot gets very close to the PSU. Next time I take it out I will take some photos!

EDIT: oh - and be careful - anti-static bags can be conductive!

23 May 2019, 01:28	#12
dalek Registered User Join Date: Nov 2014 Location: NSW/Australia Posts: 462	Nice guide - great writeup. I did the same but stupidly didn't take any pictures. What I did was put the adaptor inside the PSU case - drilled holes in the left hand side - if you look at your second to last picture it went flat against the left panel on the inside. That way the wires running out look original. Only issue with that is to try and keep the bolts flush on the outside, as on the A2000 a card in the CPU slot gets very close to the PSU. Next time I take it out I will take some photos! EDIT: oh - and be careful - anti-static bags can be conductive!