View Single Post
Old 14 October 2003, 10:32   #2
thomas
Registered User
thomas's Avatar
 
Join Date: Jan 2002
Location: Germany
Posts: 5,526
I don't know if this special network card is supported, but in order to use a PCMCIA network card in general, you need the cnet.device and perhaps a fix for the hardware fault of the A1200.

http://www.aminet.net/aminet.cgi?string=cnetdevice
http://www.aminet.net/aminet.cgi?string=cardreset
http://www.aminet.net/aminet.cgi?string=cardpatch

Then it is very easy to set up Miami. Just install a new Ethernet LAN interface and configure your IP address, network mask, default gateway and DNS and there you go.

No special config is needed for IBrowse or other programs.

Well, if you also want to share files in your LAN, you need Samba and SMBFS or SMB-Connect in addition. But this is another story.

http://www.amigasamba.org/
http://www.dmbsoft.de/

Note that Samba needs a lot of CPU power and much RAM is recommended, too.
thomas is offline  
 
Page generated in 0.05088 seconds with 9 queries