View Single Post
Old 10 July 2018, 13:05   #30
Toni Wilen
WinUAE developer
 
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 43
Posts: 21,793
http://www.winuae.net/files/b/winuae_4010b4.7z
http://www.winuae.net/files/b/winuae64_4010b4.7z

Unfortunately b1 path handling change was more complex than I assumed so there will be some more delay.. (If I would have known this, I would not have done it yet..)

Check that existing configs still work, including disk swapper.

Beta 4:

- Floppy, CD, Tape, HDF geometry, HDF filesystem, disk swapper, RTC and flash rom file paths also support b1 resolve environmental variables update. (b1 update had issues requiring partial rewrite so it was good idea to update all other paths too. Excluding special paths like ROM paths.)
- Previously only some SCSI controllers flashed CD led when emulating CD drive.

Short description about path handling change: Previously any path was always converted to either full absolute or relative path with possible environmental variables resolved when config was loaded or path was typed/selected from dialog. When config was saved, old path (possibly containing environmental variables) was lost. Now paths are loaded unmodified from config file and only converted when needed. "Normal" path strings (no environmental variables) are still automatically converted to absolute/relative when saving config.
Toni Wilen is offline  
 
Page generated in 0.03953 seconds with 10 queries