View Single Post
Old 08 July 2018, 19:43   #23
Toni Wilen
WinUAE developer
 
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 43
Posts: 22,024
http://www.winuae.net/files/b/winuae_4010b3.7z
http://www.winuae.net/files/b/winuae64_4010b3.7z

Beta 3: (Possibly final beta, I wasn't supposed to do 4.0.1 vsync updates but below updates should have been in 4.0.0..)

- If CD audio playing from real/virtual CD (not directly mounted image) was restarted because of config change, playback always started from beginning (or possibly failed to restart).
- 68060 FPU disable behavior change (68060 accelerator boards have "$f0" ROM to disable FPU because exec does not understand 68060 FPU and will crash if enabled), FPU is not anymore automatically disabled at hard reset if any emulated accelerator board is configured (matches now real world), if no accelerator board: if UAE boot ROM is at $f00000 ("old" mode), it disables FPU (just like real accelerator board do), if UAE Boot ROM is any other address: ("new" mode), m68k RESET instruction will disable FPU. Previously 68060 config got stuck in reboot loop because of not-disabled FPU if system was software reset.
- D3D9/11 vsync modes (lagless and standard) will now support 100/120Hz with optional black frame insertion.
- Always check interrupts immediately after MOVE to SR instruction (except if JIT enabled). Previously it was delayed until following instruction if fast 68020+ mode.
- Above FACOS JIT fix.
Toni Wilen is offline  
 
Page generated in 0.04061 seconds with 10 queries