English Amiga Board - View Single Post

TimT · 22 May 2018, 02:06

Hi Everyone

Received my TerribleFire 530 today! started soldering the parts I had. Installed the XC9572XL's with no problem. Then I lingered to long with a CAY16 removing the solder mask. So now the copper traces are covered in solder. So my question is do the traces connect with the 4 pads anyway? if not I will have to remove all the solder and use epoxy.

Also I see the board is marked for component orientation but some of the parts I got from digikey are not marked. is there a diagram that shows the orientation?

Thanks

22 May 2018, 02:06	#3246
TimT Registered User Join Date: May 2018 Location: Savannah Ga USA Posts: 32	Hi Everyone Received my TerribleFire 530 today! started soldering the parts I had. Installed the XC9572XL's with no problem. Then I lingered to long with a CAY16 removing the solder mask. So now the copper traces are covered in solder. So my question is do the traces connect with the 4 pads anyway? if not I will have to remove all the solder and use epoxy. Also I see the board is marked for component orientation but some of the parts I got from digikey are not marked. is there a diagram that shows the orientation? Thanks Attached Thumbnails