English Amiga Board - View Single Post - Problem getting demo starter code to work

Seboss · 14 May 2018, 00:22

To make sure the program runs in the expected screenmode/resolution, is it required to setup a new Screen via system calls or is there some way to poke the hardware to get it to run the program in - say - PAL mode regardless of the screen mode of the IDE or Workbench?

EDIT: sorry Photon if that's a question you address at some point in AsmSkool. Still working my way up from episode 21, and it's not something that has been mentioned yet at this point, if I'm not mistaken.

14 May 2018, 00:22	#65
Seboss Registered User Join Date: Feb 2018 Location: Grenoble / France Posts: 14	To make sure the program runs in the expected screenmode/resolution, is it required to setup a new Screen via system calls or is there some way to poke the hardware to get it to run the program in - say - PAL mode regardless of the screen mode of the IDE or Workbench? EDIT: sorry Photon if that's a question you address at some point in AsmSkool. Still working my way up from episode 21, and it's not something that has been mentioned yet at this point, if I'm not mistaken.