Quote:
Originally Posted by alenppc
The lowest I found in my parts drawer was 2.2K, so I fitted that. The card still won't boot without an IDE device connected to it, so I guess 1k works out better.
Still getting the same data corruption as before though. Using a 5 cm cable now.
|
Can you just confirm exactly what board you are using, is it a rev 3 ? (I think you said Rev 2), especially the version that Steve updated ? (He updated the ground planes, added extra caps between the VCC and GND etc).
I am about to do a run of Rev 3 boards I think, then when TF534 is ready.., I can do a run on those too.