Thread: RocHard RH800C
View Single Post
Old 19 May 2017, 14:42   #5
mark_k
Registered User
 
Join Date: Aug 2004
Location:
Posts: 2,476
Using a blank 20MB HDF (geometry 4 heads, 32 sectors/track, 320 cylinders) I was able to use IDE_FormatHdd to format a single FFS partition and copy the contents of a Workbench 1.3 disk to it. Then I could reset and the system booted from the HD.

(I previously had the Autoboot disabled box checked in WinUAE expansion settings. After un-checking that to allow auto-booting, just resetting the emulated Amiga didn't cause it to boot from HD. After saving the config I quit and re-ran WinUAE, then it did notice the changed autoboot setting.)

If you run WinUAE with -log -scsiemulog arguments that might shed some light on when the error message appears.
mark_k is offline  
 
Page generated in 0.05869 seconds with 9 queries